HP NonStop G-Series - Manual (Page 167)

Using the DSM/TC Software System
DSM/Tape Catalog User’s Guide — 520233-008
A - 17
Rejecting a Tape Mount
2. Enable the write protect on the labeled tape.
3. Execute the FUP COPY command on the labeled tape, which could resulted in a
tape error.
4. Set the status of the tape volume to INUSE and dismount the tape from the
tapedrive.
5. If the user had stopped either the primary ZSERVER process or brought down the
processor where ZSERVER is primaried. In either of the cases ZSERVER backup
process will take over and try to continue the operation.
6. After takeover, a new mount request will be posted by ZSERVER.
After the abort, reissue the command.