HP ProLiant ML110 G7 Server - Manual (Page 22)

Operations 22
4. Connect each power cord to the server.
5. Connect each power cord to the power source.
IMPORTANT: Be sure that the panel is locked into place securely before powering up the server.
6. Power up the server (on page 19 ).
Remove the air baffle
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
1. Power down the server (on page 19 ).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Unlock the tower bezel (" Unlock and open the tower bezel " on page 20 ).
4. Remove the access panel (on page 21 ).
CAUTION: Do not detach the cable that connects the battery pack to the cache module.
Detaching the cable causes any unsaved data in the cache module to be lost.
5. Remove the air baffle.
Install the air baffle
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.