Remove the access panel, Install the access panel – HP ProLiant ML110 G7 Server User Manual
Page 21
Operations 21
2.
Close and lock the tower bezel.
Remove the access panel
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION:
For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
1.
Power down the server (on page
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Unlock the tower bezel ("
Unlock and open the tower bezel
" on page
4.
Place the server on its side.
5.
Remove the thumbscrew on the access panel.
6.
Slide the access panel back.
7.
Lift the access panel away from the chassis.
Install the access panel
CAUTION:
Do not operate the server for long periods with the access panel open or removed.
Operating the server in this manner results in improper airflow and improper cooling that can
lead to thermal damage.
1.
Place the access panel on the chassis, and then slide it toward the front of the server.
2.
Tighten the thumbscrew.
3.
Close and lock the tower bezel.