Start automatic discovery, Interface uri, Access method – HP Intelligent Management Center Licenses User Manual
Page 122: Interface uri access method, Message body, Element description
Start Automatic Discovery
This function helps you discover manageable devices and add them to the network management
system. Automatic discovery can be in simple or advanced mode.
Interface URI
/plat/res/autodiscover/start
Access Method
HTTP
POST
Message body
Element description
autoDiscoverConfig sub-elements
Automatic discovery modes. 0: Simple mode. 1: Advanced mode. Integer type. Required.
No default value.
mode
Subnet for automatic discovery. Required. No default value. Multiple subnets are supported.
ipSection
Start IP address of the subnet. String type. Required. No default value.
begin
End IP address of the subnet. String type. Required. No default value.
end
Send traps to the network management system. Boolean type. Optional. The default value is
true.
sendTrap
Advanced type. 1: Subnet. 2: Routing. 3: IPsec. 4: Reserved (invalid). 5: ARP. 6: PPP. Integer
type. Optional. The default value is routing.
discoverType
Use the loopback address as the management IP address. Boolean type. Optional. The default
value is false.
loopBackAsManageIP
Discover non-SNMP devices. Boolean type. Optional. The default value is true.
discoverNonSnmpDevice
Scan devices on the subnet. Boolean type. Optional. The default value is false.
pingAll
Seed IP address. String type. Required. No default value. Multiple seed IP addresses are
supported.
seedIp
Filter subnet IP addresses. String type. Required. No default value. Multiple subnet IP addresses
are supported.
filterSubNetIp
Filter subnets. 1: No (discover devices in the filtered subnet). 2: Yes (not discover devices in
the filtered subnet). Long integer type. Optional. The default value is no.
filterSubNet
Discover hops. Integer type. Optional. The default value is 3.
level
SNMP parameters. For SNMP parameters, see SNMP Parameter Description. Required. No
default value. Multiple SNMP parameters are supported. If both snmpTmplId and
snmpParameter exist, snmpTmplId is preferred, and snmpParameter is omitted.
snmpParameter
122
Network Resource Management