HP 9000 Model 715.64 Workstation - Manual (Page 48)

Index-1
Index
B
bezels, adding or removing, 1–15, 3–10
C
commands
cstm, 3–6
exit, 3–8
ioscan, 2–7
verify, 3–8
cstm command, 3–6
D
data compression, operation mode, 1–10
DDS–DC drive
cassette, write–protect tab, 2–4–
2–9
cleaning the tape heads, 2–4– 2–9
configuration, 2–2
controls and features, 2–2
introduction, 1–1
LED indicators, 2–3– 2–9
display codes, 2–3
loading and unloading a cassette,
2–6
media interchangeability
restrictions, 2–4– 2–9
media life, 2–3– 2–9
ordering information, 2–9
troubleshooting, 3–2–3–12
using the drive, 2–1
verifying drive operation, 2–7
write–protecting a data cassette,
2–4– 2–9
E
environmental requirements, 1–3
exit command, SupportWave, 3–8
expansion brackets, adding or
removing, 1–15, 3–10
G
general description, 1–2
I
indicators, LED, DDS–DC drive, 2–3–
2–9
installation
OS support, 1–6
preparing the system, 1–11
adding or removing drive
bezels or expansion
brackets, 1–15
powering off, 1–14
SCSI–2 connection and
termination, 1–13
preparing to install, 1–6
setting the SCSI–2 address, 1–7
tools required, 1–6
verifying kit contents, 1–6
ioscan command, 2–7
J
jumpers, SCSI ID, DDS–DC drive, 1–9