HP Smart Update Manager (User Guide) User Manual
Page 73
You might need to provide the password if you are using a user name that is not the same as
you used to log in to the local system. All network shares require the use of the .ipv6-literal.net
name string to be properly configured by Windows.
NOTE:
You do not need to use the .ipv6-literal.net suffix when entering IPv6 address into
the HP SUM user interface or when passing IPv6 address using command line parameters to
HP SUM.
After you validate that you can access the admin$ share on the remote target server, HP SUM
works unless other network or hardware issues exist.
•
Ensure you have made the registry change on remote target servers. For more information,
see
“Configuring IPv6 for Windows Server 2003” (page 62)
.
•
Move back to an IPv4 network address to ensure HP SUM properly finds the remote target
server without any issues.
You can always copy HP SUM to the target servers and execute using the local installation method.
Troubleshooting HP SUM in IPv6 Windows Server 2008 environment
To validate that the IPv6 network is configured correctly for HP SUM support, you must verify the
following based on your operating system version.
•
Validate that you can ping the remote target server. With computers running Windows, you
can still use the ping command to ping IPv6 addresses:
ping
•
Ensure you can ping the IPv6 loopback address:
ping ::1
•
Use the DNS hostname instead of IPv6 address to ensure the address is correct.
•
Verify that you can connect to the admin$ share using the credentials within HP SUM by
issuing the following command at a console prompt:
net use * \\
net use * \\fec0::2.ipv6-literal.net\admin$ /user:administrator
You might need to provide the password if you use a user name that is different from the one
you used to log in to the local system. All network shares require the use of the .ipv6-literal.net
name string to be properly configured by Windows.
After you validate you can access the admin$ share on the remote target server, HP SUM
works unless there are other network or hardware issues.
Troubleshooting HP SUM in IPv6 Red Hat and Novell SUSE-based Linux environments
•
Verify that you can establish an SSH connection to the remote target server using the credentials
within HP SUM by issuing the following command at a console prompt:
ssh <ipv6 address>
ssh 2101:db8:0:1::9
You must enter the root password for the target Linux server at the console to complete the
IPv6 connection.
•
Validate that you can ping the remote target server. In Linux, you need to use the ping6
command to ping IPv6 addresses:
ping6 <ipv6 address>
IPv6 network issues
73