HP Smart Update Manager (User Guide) - Manual (Page 52)

Possible values Description Parameter
If no bundles are specified on the
command line, and multiple bundles
are in the directory, this parameter
enables HP SUM to use the bundle
that has the latest version for
installation.
YES , NO Simulates the installation for a test run.
Nothing is installed. DRYRUN
One or more CLI switch Specify the HP SUM CLI options inside
the input file, which overrides the OPTIONS
configuration settings. Parameters can
be separated by a semi-colon, comma,
or a space.
This parameter replaces the
LSPOPTIONS
parameter that was
previously supported with LDU.
Yes Specifies that components that use
SNMP, AMS, and WBEM Providers NOMGMT
No
listed as optional updates on the
Components Selection screen.
In silent mode, HP SUM does not
update SNMP, AMS, or WBEM
Providers.
YES , NO Specifies that components that use
SNMP protocol, are available to be
selected for installation. USESNMP
These components are available for
selection by default. When the
/usesnmp
parameter is used, and the
/usewmi parameter is not used, the
WMI components are optional. This
parameter does not apply to HP
Integrity servers.
YES , NO Specifies that components that use
WMI protocol are available to be
selected for installation. USEWMI
These components are optional by
default and are not installed unless this
parameter is used. When the
/usewmi
parameter is used, and the
/usesnmp parameter is not used, the
SNMP components are optional. This
parameter does not apply to HP
Integrity servers.
YES , NO This is a filter switch that allows you
to view only the firmware components
required for installation. ROMONLY
Do not use the /romonly parameter
with the /softwareonly parameter.
YES , NO This is a filter switch that allows you
to view only the software components
required for installation. SOFTWAREONLY
Do not use the /softwareonly
parameter with the /romonly
parameter.
52 Using scripts to deploy updates