HP Smart Update Manager (User Guide) - Manual (Page 57)

Possible values Description Parameter
CERTLIST parameter to
enable access to the server.
relationship mode. (Applies to Linux
PSP only.)
•
TrustByName—If you use this
value, you must define the
XENAMELIST
.
• TrustByAll—HP does not
recommend using this value
because of possible negative
security consequences.
CAUTION: The accepted
values are case-sensitive and
must be capitalized as shown.
Failure to do so prevents the
trust relationship from being set
up properly during installation
and might affect access to the
web server.
Certificate file name or Server
DNS name Enables you to provide a list of
certificate files or servers where CERTLIST
certificates can be obtained for trust
relationships for the HP Systems
Management Homepage. (Applies to
Linux PSP only.)
Server DNS name Enables you to provide a list of
servers, separated by semicolons, for XENAMELIST
trust relationships for the HP Systems
Management Homepage. (Applies to
Linux PSP only.)
This parameter is valid only if the
TRUSTMODE
parameter is set to
TrustByName . (Applies to Linux PSP
only.)
The hp_qla2x00 QLogic Fibre
Channel Driver uses this parameter to HPQLA2X00FO • SinglePath
•
SecurePath
determine the failover mode to use.
(Applies to Linux PSP only.)
•
QLogicFailure
NOTE: No default value
Y , N (default) The hp_qla2x00 QLogic Fibre
Channel Driver uses this parameter to HPQLA2X00FORCE
determine whether to skip detection of
third-party storage. (Applies to Linux
PSP only.)
User can define the OAUID
variable multiple times before each
HOST
variable.
Provides the user name credentials for
the OA associated with VC. You must
define a value of these variables
before the HOST variable in the OAUID
[TARGETS] section. This parameter
applies only for VC firmware.
You can also use OAUSER or
OAUSERNAME
.
User can define OAPWD variable
multiple times before each HOST
variable. Provides the password credentials for
the OA associated with VC. You must
define a value of these variables
before the HOST variable in the OAPWD
[TARGETS] section. This parameter
applies only for VC firmware.
Input files 57