Gap setting for vibration switch, Warning – Alliance Laundry Systems PHM802N User Manual

Page 27

Specifications and Dimensions

F8138601

Gap Setting for Vibration Switch

After the machine has been properly installed, the

vibration switch gap must be verified. To locate the

vibration switch refer to Figures 14, 15 and 16. For

UniLinc models, while the control is displaying the

Inputs Outputs Menu the alarm will sound when the

frame switch is activated. To verify and set the

vibration switch gap use the following procedures:

For UniLinc Models, Navigate to the Inputs
Outputs Menu:

1. From the Cycle Menu press and hold the

keys to enter the System Menu.

2. Press the arrow keys to highlight the Diagnostic

box.

3. Press the

key to enter the Diagnostic Menu.

4. Press the

key to enter the Test Menu.

5. Press the arrow keys to highlight the Inputs

Outputs box.

6. Press the

key to enter the Inputs Outputs

Menu.

Verify Vibration Switch Gap
(for 35-125 Pound Models):

1. Insert 0.009 inch feeler gauge between the

adjustment bolt and the vibration switch; the

alarm must not activate.

2. Remove the feeler gauge.
3. Insert 0.010 inch feeler gauge (supplied with

machine) between the adjustment bolt and the

vibration switch; the alarm must activate.

4. Remove the feeler gauge.
5. Adjust the vibration switch adjustment bolt if

necessary.

Verify Vibration Switch Gap
(For 150 Pound Models):

1. Insert the 0.010 inch feeler gauge (supplied with

machine) between the adjustment bolt and the

vibration switch.

2. If alarm is active: Slowly loosen adjustment bolt

until the alarm stops.

3. Very slowly tighten the adjustment bolt until the

alarm activates. The adjustment bolt must be

tightened very slowly to prevent over adjustment.

4. Remove the feeler gauge.
5. Verify the Frame Switch setting.

To adjust the vibration switch gap on the 150 models,

move the vibration switch by adjusting the jam nuts on

the vibration switch.
For UniLinc models, to return to the Cycle Menu press

BACK key several times until Cycle Menu is

displayed.

Only trained personnel should perform this

procedure. Use caution while servicing

machines with covers removed and power

applied.

W700

WARNING

This manual is related to the following products:

PHM798N