Aastra Telecom SIP 57I - Manual (Page 583)

Operational, Basic, and Advanced Parameters
41-001160-00, Release 2.1, Rev 04 A-81
Configuration Parameters
Appendix A
Autodial Settings
Global Settings
Parameter –
sip lineN srtp mode Aastra Web UI Advanced Settings->Line <1-9>->RTP Settings
Configuration Files aastra.cfg, .cfg
Description This parameter determines if SRTP is enabled on this line, as follows:
• If set to -1, then use the global setting for this line. (This is the
default setting.)
• If set to 0, then disable SRTP.
• If set to 1 then SRTP calls are preferred.
• If set to 2, then SRTP calls only are generated/accepted.
Format Integer
Default Value 0 (disabled)
Range -1
0
1
2
Example sip line1 mode: 1
Parameter –
sip autodial number
Autodial Number
(in Web UI)
Aastra Web UI Advanced Settings>Global SIP>
Autodial Settings
Configuration Files aastra.cfg, .cfg
Description Globally specifies the SIP phone number that the IP phone autodials
when the handset is lifted from the phone cradle. An empty (blank)
value disables autodial on the phone.
Format Integer
Default Value Blank
Range Any valid SIP number
Examples sip autodial number: 8500