Insufficient paper for job, This paper cannot be used as size is not supported – Canon imagePROGRAF iPF8400S User Manual

Page 959

Cause

Corrective Action

Paper has been loaded askew, or warped paper has been loaded.

If this error recurs after you reload the roll, re-
move the Roll Holder from the printer, push the
roll firmly in until it touches the Roll Holder
flange, and reload the Roll Holder in the print-
er.
(See "Attaching the Roll Holder to
Rolls.")

➔

P.507

Because the Platen is soiled with ink or other substances, the size of the clear film cannot
be detected.

Open the Top Cover and clean the entire Plat-
en.
(See "Cleaning Inside the Top Cov-
er.")

➔

P.907

Insufficient paper for job

Cause

Corrective Action

The printer has received a print job longer than the amount of roll paper left when
ManageRemainRoll in the Control Panel menu is On.

Press ▲ or ▼ to select Print, and then press the OK
button to resume printing.
When using the Media Take-up Unit, press ▲ or ▼ to
select Print, and then press the OK button to resume
printing.
However, the roll paper may run out during the print job
and you may not be able to print all of the document.

Press ▲ or ▼ to select Change Paper, and then press
the OK button.
Change the Paper Source of the printer driver, or re-
place the roll with a roll that has enough paper for the
print job, and then printt.
When using the Media Take-up Unit, press ▲ or ▼ to
select Stop Printing, and then press the OK button to
stop printing.
Remove the printed document from the Media Take-up
Unit, replace the roll with a roll that has enough paper
for the print job, and then try printing again.
(See "Removing the Roll from the Printer.")