Canon imagePROGRAF iPF8400S - Manual (Page 939)

Cause Corrective Action
The Printhead is out of alignment. Adjust the Printhead alignment.
(See "Automatic Adjustment to Straighten Lines and Colors.")
➔ P.768
Allowing printed documents to dry on top of
each other may cause uneven colors. To avoid uneven colors, we recommend drying each sheet separately.
Density may be uneven if you use Glossy
Paper or Canon Coated Paper. In Advanced Settings of the printer driver, choose Highest quality or High in Print Quality.
The type of paper specified in the printer
driver does not match the type loaded in
the printer. Load paper of the same type as you have specified in the printer driver.
(See "Loading Rolls in the Printer.")
➔ P.510
(See "Loading Sheets in the Printer.") ➔ P.533
Make sure the same type of paper is specified in the printer driver as you have loaded in the
printer.
1. Press the Stop button and stop printing.
2. Change the type of paper in the printer driver and try printing again.
Scan Wait Time > Area in the Control
Panel menu is set to Leading edge. When Scan Wait Time > Area is set to Leading edge, colors may be uneven 110–160 mm from
the leading edge. (The position varies depending on the Print Quality setting.)
In this case, select Scan Wait Time > Area > Entire area.
However, note that printing will now take longer.
(See "Menu Settings.")
➔ P.641
Image edges are blurred or white banding occurs Image edges are blurred or white banding occurs
Cause Corrective Action
The Platen suction is too strong. In the Control Panel menu, reduce the level of VacuumStrngth.
(See "Adjusting the Vacuum Strength.")
➔ P.780
Close the blue Switch on the platen so that it matches the paper size.
(See "Setting the Blue Switch on the Platen.")
➔ P.939
Incorrect Printhead alignment value. When printing fine lines or text at high precision on glossy or semi-glossy photo or proofing paper, set
the optimal Printhead height before aligning the printhead.
(See "Enhancing Printing Quality.")
➔ P.766
In the Control Panel menu, set Head Height to a lower height.
(See "Troubleshooting Paper Abrasion and Blurry Images.")
➔ P.773
The type of paper specified in the
printer driver does not match the type
loaded in the printer. Load paper of the same type as you have specified in the printer driver.
(See "Loading Rolls in the Printer.")
➔ P.510
(See "Loading Sheets in the Printer.")
➔ P.533
Make sure the same type of paper is specified in the printer driver as you have loaded in the printer.
1. Press the Stop button and stop printing.
2. Change the type of paper in the printer driver and try printing again.
Setting the Blue Switch on the Platen Setting the Blue Switch on the Platen
If printed documents exhibit the following symptoms, adjust the setting of the blue Switch on the Platen.
• Image edges are blurred
• Image edges are affected by white banding
Important
• Always set all of the blue Switches on the Platen to the ● side for borderless printing. If the Switch are not set correctly, the
print quality may deteriorate.
1
Remove any loaded paper that will not be used.
• Rolls (See "Removing the Roll from the Printer.")
➔ P.517
• Sheet (See "Removing Sheets.")
➔ P.539
iPF8400S Image edges are blurred or white banding occurs
User's Guide
Troubleshooting
Problems with the printing quality
939