Canon EOS C300 - Manual (Page 94)

Special Recording Modes
94
4 Press the START/STOP button again to stop recording.
• All of the recorded frames are joined together into one clip.
• The tally lamps go out and [INT STBY] appears at the top of the screen (with [INT] flashing).
NOTES
• You can use only one special recording mode at a time.
• While recording, you cannot change the interval or number of frames.
• Some frames at the point the recording was stopped may be recorded and added to the end of the clip.
• Interval recording mode will be deactivated if the special recording mode is changed or turned off. It will be
deactivated also if you change the [w Other Functions] > [24.00P], [NTSC/PAL], [Bit Rate/Resolution] or
[Frame Rate] setting.
• The time code advances by the number of frames recorded. If the running mode of the time code (A 73) is
set to [Free Run] or the time code is input from an external source, the running mode will switch to [Rec Run]
during special recording mode. When special recording mode is deactivated, the running mode will return to
its previous setting.
• During special recording mode, the time code signal will not be output from the TIME CODE terminal or
HD/SD SDI terminal.
Frame Recording Mode
Set the number of frames in advance. We recommend operating the camcorder remotely or stabilizing the
camcorder, for example, on a tripod. Sound is not recorded in this mode.
Configuring Frame Recording Mode
1 Open the [Rec Frames] submenu.
[w Other Functions] > [Frame Rec] > [Rec Frames]
2 Select the desired number of frames and then press SET.
• Available options depend on the frame rate used: 1, 3, 6 and 9
frames (when [w Other Functions] > [24.00P] is set to [On] or
[Frame Rate] is set to [23.98P], [29.97P] or [59.94i]) or 2, 6 and 12
frames (when [w Other Functions] > [Frame Rate] is set to [25.00P],
[50.00i], [50.00P] or [59.94P]).
Activating Frame Recording Mode and Recording
1 Open the [Special Rec] submenu.
[w Other Functions] > [Special Rec]
2 Select [Frame Rec] and then press SET.
• [FRM STBY] appears at the top of the screen (with [FRM] flashing).
3 Press the START/STOP button to begin recording.
• The camcorder automatically records the set number of frames.
• The tally lamp illuminates.
• [FRM STBY] changes to [Ü FRM REC] while recording frames and [Ü FRM STBY] when frames are not
being recorded.
• Repeat until you finish recording.
4 Open the [Special Rec] submenu.
[w Other Functions] > [Special Rec]
[w Other Functions]
[ Frame Rec]
[Rec Frames]
[1]
[w Other Functions]
[ Special Rec]
[Off]
COP
Y