Canon EOS C300 - Manual (Page 50)

Recording Video
50
2 Press the START/STOP button to begin recording.
• Recording starts. The tally lamp illuminates and the recording
indicator [ÜREC] appears at the top of the screen.
• You can use the START/STOP button on the back of the
camcorder, the front of the camcorder (next to the lens
mount), the grip unit or the monitor unit.
3 Press the START/STOP button to pause the recording.
• The clip* is recorded to the CF card and the camcorder enters
record pause mode. The tally lamp will also go out.
* “Clip” refers to one movie unit from the point you press the START/STOP
button to start recording until you press again to pause the recording. You can
also include custom picture settings (A 101) and metadata (A 85) with the
clip.
Remote Operation Using Wi-Fi Remote
After completing the necessary preparations (A 47) you can start and stop recording from a Wi-Fi-enabled
device using the Wi-Fi Remote application.
1 Press [LIVE VIEW ON/OFF] to show the camcorder’s live view image on the Wi-Fi Remote screen.
2 Press [START/STOP] to begin recording.
• The recording operation indicator changes from [STBY] to [ÜREC], the center of the START/STOP button
lights up in red and the time code display starts running on the Wi-Fi Remote screen.
• Press [START/STOP] again to pause the recording.
IMPORTANT
• Observe the following precautions while the CF2 or CF3 access indicator is illuminated in red. Failure to do
so may result in permanent data loss.
- Do not open the CF card slot cover of the CF card slot being accessed and remove the CF card.
- Do not disconnect the power source or turn off the camcorder.
• Be sure to save your recordings regularly (A 132), especially after making important recordings. Canon shall
not be liable for any loss or corruption of data.
NOTES
• You can use [w Other Functions] > [Rec Review] (A 92) to review part or all of the last clip recorded.
• If you set an assignable button to [Add $ Mark] or [Add % Mark] (A 99), you can press the button to add
an $ mark or % mark to the last clip recorded.
Recording operation
Time code
COP
Y