Canon PIXMA iP8750 - Manual (Page 149)

6. TCP/IP Setting:
Sets the IP address of the printer to be used over the LAN. Specify a value appropriate for your
network environment.
Get IP address automatically
Select this option to use an IP address automatically assigned by a DHCP server. DHCP
server functionality must be enabled on your wireless LAN router or access point.
Use following IP address
If no DHCP server functionality is available in your setup where you use the printer or you
want to use a particular IP address, select this option to use a fixed IP address.
• Access Points Screen
1. Detected Access Points:
The signal strength from the access point, encryption type, name of access point, and the radio
channel can be confirmed.
Important
• If you connect to a network that is not protected with security measures, there is a risk of
disclosing data such as your personal information to a third party.
Note
• Signal strength is displayed as follows.
: Good
: Fair
: Poor
• Type of encryption is displayed as follows.
Blank: No encryption
WEP: WEP is set
WPA: WPA is set
WPA2: WPA2 is set
149