Canon VB-H41 - Manual (Page 78)

78
(1) [LAN]
LAN interface, maximum packet size settings (p. 47)
(2) [IPv4]
IP address, IPv4 settings, etc. (p. 47)
(3) [IPv6]
Settings regarding IPv6 (p. 48)
(4) [Installation Conditions]
Dome setting (p. 54)
(5) [HTTP Server]
Authentication method, HTTP, and HTTPS port
settings (p. 63)
[Reboot Item] Setting Items Requiring Rebooting
The following settings that require rebooting before
changes take effect can be found on a single page.
• LAN, IPv4, IPv6, Installation Conditions (VB-H41
only), HTTP Server
Important
These settings relate to network connectivity. If any setting is
changed to a value that may disable camera connection from
the active web browser, a dialog box appears and alerts the
user.
Click [OK] to apply the new setting.
Depending on the new setting, it may not be possible to
connect to the camera again after rebooting. If this happens, a
candidate URI for reconnecting the camera will appear if
available.
Try the URI displayed to reconnect the camera.
If you cannot connect to the camera through the displayed URI,
contact your System Administrator.
* Settings related to network connectivity in the [Reboot Item] menu
are [LAN Interface], [Maximum Packet Size], [IPv4 Address
Setting Method], [IPv4 Address], [Subnet Mask], [IPv4 Default
Gateway Address], [AutoIP], [IPv6], [Auto (RA)], [Auto
(DHCPv6)], [IPv6 Address (Manual)], [Prefix Length], [IPv6
Default Gateway Address], [HTTP Port] and [HTTPS Port].