Canon VB-H41 - Manual (Page 157)

List of Log Messages
157
8
Appen
di
x
„ Application (SD Memory Card) Messages
M001 Starting and stopping of SD memory card
control module [info]
M201 SD memory card write protection [warning]
M203 Not enough space on SD memory card [warning]
M204 Invalid file removed [warning]
M301 SD memory card control module error [err]
„ HTTP Server Messages
H143 User name specification error [notice]
H144 Password specification error [notice]
H201 Timeout disconnect [warning]
„ System Messages
S001 System started [info]
S002 System settings changed [info]
S010 Event service started [info]
S011 Event service shut down [info]
S012 External device service started [info]
S013 External device service shut down [info]
S014 Timer service started [info]
S015 Timer service shut down [info]
Description %1 sdctrl (M001)
%1 Starting or stopping
Meaning The SD memory card control module (sdctrl)
has started or stopped.
Description Read only filesystem (M201)
Meaning A write-protected SD memory card is
inserted.
Description There is not available space (M203)
Meaning Insufficient SD memory card capacity.
Description Invalid file %1 was removed. (M204)
%1 Name of removed file
Meaning An invalid file was removed.
Description %1 process failure (M301)
%1 mount or unmount
Meaning Mount or unmount process failed.
Description (http_auth.c.XXX) get_password failed,
IP:%1 (H143)
%1 IP address
Meaning An unknown user was specified in user
authentication.
Description (http_auth.c.XXX) password doesn't match
for %1 username%2, IP:%3 (H144)
%1 URL XSS vulnerability countermeasure
implementation (process equivalent to ftpd)
%2 User Name
%3 IP address
Meaning A wrong password was specified in user
authentication.
Description a request for %1 timed out after writing %d
seconds (H201)
%1 Request URI
%d 360 (Timeout time)
Meaning Disconnected due to HTTP server timeout
(360 sec.).
Description starting paramd (S001)
Meaning Parameter management module started.
Description Updated system settings. (S002)
Meaning Settings not requiring rebooting were
changed.
Description starting event (S010)
Meaning The event service was started.
Description shutdown event (S011)
Meaning The event service was shut down.
Description starting extio (S012)
Meaning The external device input/output service
was started.
Description shutdown extio (S013)
Meaning The external device input/output service
was shut down.
Description starting timer (S014)
Meaning The timer service was started.
Description shutdown timer (S015)
Meaning The timer service was shut down.