Brother MFC J6510DW - Manual (Page 29)

24
4
4
Before configuring the wireless settings
4
IMPORTANT
• The following instructions will install your Brother machine in a network environment using the Brother
installer application found on the installation CD-ROM we have provided with the machine.
• You can also setup your Brother machine using WPS or AOSS™ from the control panel which we
recommend. You can find instructions in the supplied Quick Setup Guide.
• If you have previously configured the wireless settings of the machine, you must reset the network LAN
settings before you can configure the wireless settings again.
Press Menu, a or b to choose Network, press OK. Press a or b to choose Network Reset, press OK.
Press 1 to reset and then press 1 to accept the change. For Touchscreen models, press MENU, Network.
Press a or b to display Network Reset, and press Network Reset. Press Yes to reset and then press
Yes for 2 seconds to confirm. The machine will restart automatically.
• If you are using a firewall function of anti-spyware or antivirus applications, temporarily disable them. Once
you are sure that you can print please re-enable your firewall.
• You need to temporarily use a USB cable (not included) or Ethernet cable (not included) during
configuration.
• You must know your wireless network settings before you proceed with this installation.
If you are going to connect your Brother machine to your network, we recommend that you contact your
system administrator prior to installation.
• If your router uses WEP encryption, enter the key used as the first WEP key. Your Brother machine
supports the use of the first WEP key only.
Wireless configuration using the Brother
installer application
4