Brother DCP-J140W - Manual (Page 136)

ControlCenter2
129
7
File
7
The Scan to File button lets you scan an image to a folder on your hard drive in any file format. This lets you
easily archive your paper documents. To configure the file type and folder, click the button while holding down
the Ctrl key and choose the Software Button.
You can change the File Name. Enter the file name you want to use for the document (up to 100 characters)
in the File Name box. The File name will be the file name you registered, current date and sequential number.
Choose the file type for the saved image from the File Type drop-down list. You can save the file to the default
folder, or choose your preferred folder by clicking Browse.
To show where the scanned image is saved when scanning is finished, check the Show Folder box. To
specify the destination of the scanned image everytime, check Show Save As window box.
If you want to scan and then crop a portion of a page after pre-scanning the document, check the
Show Scanner Interface box.