Brother MFC-8510DN User Manual
Page 99
Troubleshooting
87
B
Out of Memory
Secure Print Data
is full.
The machine’s memory is full.
Press Stop/Exit and delete the previously
stored secure print data.
See Software User's Guide: Secure Print Key.
Print Unable XX
The machine has a mechanical
problem.
Do one of the following:
Turn the power switch off, wait a few
minutes, and then turn it on again.
(See Transferring your faxes or Fax Journal
report uu page 90.)
If the problem continues, call Brother
Customer Service.
Protected Device
The protect switch of the USB
Flash memory drive is on.
Turn off the protect switch of the USB Flash
memory drive.
Rename the File
There is already a file on the
USB Flash memory drive with
the same name as the file you
are trying to save.
Change the file name of the file on the USB
Flash memory drive or the file you are trying to
save.
Replace Parts
Drum
It is time to replace the drum
unit.
Replace the drum unit.
(See Replacing the drum unit uu page 77.)
The drum unit counter was not
reset when a new drum was
installed.
Reset the drum unit counter.
(See Replacing the drum unit uu page 77.)
Replace Parts
Fuser Unit
It is time to replace the fuser
unit.
Call Brother Customer Service or a Brother
Authorized Service Center to replace the fuser
unit.
To replace Fuser Unit call Brother Customer
Service at:
1-877-BROTHER (1-877-276-8437) (in USA)
1-877-BROTHER (in Canada)
or to locate a Brother Authorized Service
Center, visit us at:
Replace Parts
Laser Unit
It is time to replace the laser
unit.
Call Brother Customer Service or a Brother
Authorized Service Center to replace the laser
unit.
To replace Laser Unit call Brother Customer
Service at:
1-877-BROTHER (1-877-276-8437) (in USA)
1-877-BROTHER (in Canada)
or to locate a Brother Authorized Service
Center, visit us at:
Error Message
Cause
Action