Brother MFC-8510DN - Manual (Page 52)

Chapter 7
40
Turning off distinctive ring
7
a
Press Menu, 2, 0, 2.
20.Miscellaneous
2.Distinctive
a On
b Off
Select ab or OK
b
Press a or b to choose Off.
Press OK.
c
Press Stop/Exit.
Note
If you do not want to receive faxes on your
Distinctive Ring number, you can turn off
Distinctive Ring. The machine will stay in
Manual
receive mode so you will need to
set the Receive Mode again. (See Choose
the correct Receive Mode uu page 30.)
Connecting an external
TAD (telephone
answering device)
7
You can connect an external Telephone
Answering Device (TAD) to the same line as
your machine. When the TAD answers a call,
your machine will “listen” for the CNG (fax
calling) tones sent by a sending fax machine.
If it hears them it will take over the call and
receive the fax. If it does not hear them, it will
let your TAD take a voice message and the
display will show Telephone.
The external TAD must answer within four
rings (we recommend you set it to two rings).
This is because your machine cannot hear
the CNG tones until the external TAD has
picked up the call. The sending machine will
send CNG tones for only eight to ten seconds
longer. We do not recommend using the toll
saver feature on your external TAD if it needs
more than four rings to activate it.
Unless you are using Distinctive Ring, the
TAD must be connected to the EXT. jack of
the machine.
Before you connect an external TAD
(telephone answering device), remove the
protective cap (2) from the EXT. jack on the
machine.
1 TAD
2 Protective Cap
Note
If you have problems receiving faxes,
reduce the ring delay setting on your
external TAD.
2
1
1