Brother MFC-8510DN User Manual
Page 97
Troubleshooting
85
B
Drum Stop
It is time to replace the drum
unit.
Replace the drum unit.
(See Replacing the drum unit uu page 77.)
Duplex Disabled
The back of the machine is not
closed completely.
Close the back cover of the machine.
Fuser Error
The temperature of the fuser
unit does not rise to a specified
temperature within the
specified time.
Turn the power switch off, wait a few seconds,
and then turn it on again. Leave the machine
idle for 15 minutes with the power on.
The fuser unit is too hot.
Jam Duplex
The paper is jammed in the
duplex tray or the fuser unit.
See Paper is jammed in the duplex tray
uu
Jam Inside
The paper is jammed inside the
machine.
See Paper is jammed inside the machine
uu
The toner cartridge is placed in
the machine without the drum
unit.
Put the toner cartridge into the drum unit, and
then re-install the drum unit and toner cartridge
assembly in the machine.
Jam MP Tray
The paper is jammed in the MP
tray of the machine.
See Paper is jammed in the MP tray
uu
Jam Rear
The paper is jammed in the
back of the machine.
See Paper is jammed at the back of the
machine uu page 95.
Jam Tray 1
Jam Tray 2
The paper is jammed in the
paper tray of the machine.
See Paper is jammed in paper tray 1 or tray 2
uu
Limit Exceeded
The printing limit set by Secure
Function Lock 2.0 was
reached.
Contact your administrator to check your
Secure Function Lock Settings.
Log Access Error
The machine could not access
the print log file in the server.
Contact your administrator to check the Store
Print Log to Network settings.
For detailed information uu Network User's
Guide: Store Print Log to Network
Manual Feed
Manual was selected as the
paper source when there was
no paper in the MP tray.
Place paper in the MP tray. If the machine is in
Pause mode, press Start.
(See Loading paper in the multi-purpose tray
(MP tray) uu page 11.)
No HUB Support
A USB hub device is
connected to the USB direct
interface.
Disconnect the USB hub device from the USB
direct interface.
No Paper
The machine is out of paper in
the specified tray or all trays, or
paper is not correctly loaded in
the paper tray.
Do one of the following:
Refill paper in the paper tray shown on the
LCD. Make sure the paper guides are set to
the correct size.
Remove the paper and load it again. Make
sure the paper guides are set to the correct
size.
Error Message
Cause
Action