Co specify machine settings (cut options), Specify machine settings (cut options) – Brother TD-4100N User Manual
Page 34
^CO
Specify machine settings (cut options)
[ASCII]
^ C O n1 n2 n3 n4
[Decimal]
94 67 79 nd1 nd2 nd3 nd4
[Hexadecimal]
5E 43 4F nh1 nh2 nh3 nh4
[Parameters]
0≤n1≤1
0≤n2≤9
0≤n3≤9
0≤n4≤1
[Description]
・
Specifies the various cut options.
n1:
Auto cut setting
(ON: 1 (default); OFF: 0)
(n2*10)+n3:
Auto cut label number setting (1 to 99)
(Default value: 1)
n4:
Cut at end setting
(ON: 1 (default); OFF: 0)
・
This command is a dynamic command.
[Remarks]
・
The auto cut label number setting can be between 1 and 99. This is invalid when an
attempt is made to specify a value other than these.
[Example]
・
To cut after every two labels:
Since the auto cut setting will be set to ON and the auto cut label number will be two
labels, n1=1, n2=0 and n3=2. Therefore, the command will be as follows.
^ C O 1 0 2 0
(5Eh 43h 4Fh 31h 30h 32h 30h)
14