Brother MW-260 - Manual (Page 49)

49
[Decimal 1 byte] 0
[Decimal 1 byte] 18
[Decimal 1 byte] 32
[Decimal 1 byte] 26
[Decimal 1 byte] 36
[Decimal 1 byte] 36
[Decimal 1 byte] 48
-ECC200 Rectangle:
In case of height count of cells is automatically;
Width count of cells automatically
In case of height count of 8 cells;
Width count of 18 cells
Width count of 32 cells
In case of height count of 12 cells;
Width count of cells 26
Width count of cells 36
In case of height count of 16 cells;
Width count of cells 36
Width count of cells 48
5. System Reserved
[Decimal 1 byte] * 5 0
5 bytes of Dummy data “0” are sent.
[Description]
The height cell size is changed to ”auto setting” automatically when the incorrect height cell size value is
set for the ECC200 Square symbol. If you input different values of width and height cell size when
specifying the ECC200 Square, the height cell size is changed to the same value as the width cell size
since width size is the priority value.
Incorrect values are changed to “auto setting” automatically when either the height or width cell size are
wrong.
[Bar code data]: maximum bar code data size:
The maximum is 2,335 characters of alphanumeric, 3,116 characters of numeric or 1,556 bytes of binary
to input bar code data.
Note: Above “maximum data size” is applied under settings with maximum cell size (144 cells x 144 cells).
According to cell size settings, “maximum data size” may be decreased.
Data end sign.
For 2D code, 3 backslashes “\\\” should be required at the end of the data.
[Input sample]
You would input the following conditions, please refer to the sample code below.
Cell size: 3 dots
Symbol type: ECC Square 40 x 40
Data: “12345”
ESC iD 03h 00h 28h(40d) 28h 00h 00h 00h 00h 00h “12345”
\\\