Brother MW-260 - Manual (Page 26)

DC4 Cancel auto-cancelling double-width characters
[ASCII] DC4
[Decimal] 20
[Hexadecimal] 14
[Parameters] None
[Description]
・ Cancels the double-width characters specified using ESC SO or SO.
ESC - Apply/cancel underlining
[ASCII] ESC - n
[Decimal] 27 45 n
[Hexadecimal] 1B 2D n
[Parameters] n=0, 1, 2, 3, 4
[Description]
・ Applies and cancels underlining.
・ If n=4, underlining with a width of 4 dots is applied. **
・ If n=3, underlining with a width of 3 dots is applied. **
・ If n=2, underlining with a width of 2 dots is applied. **
・ If n=1, underlining with a width of 1 dots is applied.
・ If n=0, underlining is cancelled.
・ Available at any point in the text line.
ESC ! Global formatting
[ASCII] ESC ! n
[Decimal] 27 33 n
[Hexadecimal] 1B 21 n
[Parameters] 0≤n≤255
[Description]
・ Specifies a combination of the various print modes.
Bit 7 6 5 4 3 2 1 0
If "1" Underline Italics Double width Double height Bold Reduced Proportional 12 cpi
If "0" Cancel Cancel Cancel Cancel Cancel Cancel Cancel 10 cpi
Setting Bit 5 comes before setting Bit 2.
The setting of “Bit 0” is available only when “Bit 1” is set with a parameter “0”.
26