Brother MW-260 - Manual (Page 27)

27
ESC SP Select character spacing for ANK characters
[ASCII] ESC SP n
[Decimal] 27 32 n
[Hexadecimal] 1B 20 n
[Parameters] 0≤n≤127
[Description]
・ Specifies the character spacing.
・ The default setting is n=0.
ESC X Select alphanumeric/kana character size
[ASCII] ESC X m nL nH
[Decimal] 27 88 m nL nH
[Hexadecimal] 1C 58 m nL nH
Bitmap fonts (MW-120 / MW-120 TypeF / MW-140BT / MW-140BT TypeF / MW-145BT / MW-260)
[Parameters] Character width: The value of m is irrelevant.
Character size: nL = 24, 32, or 48 dots
Available only when nH=0.
[Description]
・ This command is only used to change the size.
・ Underlining must not be specified.
・ Character width cannot be specified.
・ The character size is set to n=nL+nH*256 dots.
・ The width and the height is the same size.
・ Only n=24, 32, or 48 are available.
** These parameters are supported by MW-145BT / MW-260.
Outline fonts (MW-145BT / MW-260)**
[Parameters] Character width: The value of m is irrelevant.
Character size:
nL = 33, 38, 42, 46, 50, 58, 67, 75, 83, 92, 100, 117, 133, 150, 167,
200 or 233 dots
nH=0.
nL = 11 (267), 44 (300), 77 (333), 111 (367) or 144 (400) dots
nH=1.