E-m-hc2 probes-v1_26 – ROTRONIC HC2 User Manual

Page 11

E-M-HC2 Probes-V1_26

Rotronic AG
Bassersdorf, Switzerland

Document code

Unit

HygroClip 2 (HC2) Humidity Temperature
Probes: User Guide

Instruction Manual

Document Type

Page 11 of 31

Document title

Measurement in compressed air conduits and vessels (fixed installation)

For use with transmitters and data loggers

HC2-IE102
HC2-IE105

Humidity measuring range: 0…100 %RH
Temperature limits at sensor -100…200 °C (-148…392 °F)
G ½” thread for maximum 100 bar / 1450 PSI
Probe cable length.: 2 m (6.5 ft) or 5 m (16.4 ft)
Barrel: stainless steel
Filter base (SP-MSB15). Filter cartridge to be ordered separately
Weight with 2 m cable: approx. 290 g (10.2 oz), + 80 g (2.8 oz) per additional
meter

HC2-IE302
HC2-IE305

Humidity measuring range: 0…100 %RH
Temperature limits at sensor -100…200 °C (-148…392 °F)
NPT ½” thread for maximum 100 bar / 1450 PSI
Probe cable length.: 2 m (6.5 ft) or 5 m (16.4 ft)
Barrel: stainless steel
Filter base (SP-MSB15). Filter cartridge to be ordered separately (see
Accessories)
Weight with 2 m cable: approx. 290 g (10.2 oz), + 80 g (2.8 oz) per additional
meter

HC2-IE102-M
HC2-IE105-M

Humidity measuring range: 0…100 %RH
Temperature limits at sensor -100…200 °C (-148…392 °F)
G ½” thread for maximum 100 bar / 1450 PSI
Probe cable length.: 2 m (6.5 ft) or 5 m (16.4 ft)
Barrel: stainless steel
Filter base (SP-MSB15). Filter cartridge to be ordered separately
Weight with 2 m cable: approx. 340 g (12.0 oz), + 80 g (2.8 oz) per additional
meter

HC2-IE302-M
HC2-IE305-M

Humidity measuring range: 0…100 %RH
Temperature limits at sensor -100…200 °C (-148…392 °F)
NPT ½” thread for maximum 100 bar / 1450 PSI
Probe cable length.: 2 m (6.5 ft) or 5 m (16.4 ft)
Barrel: stainless steel
Filter base (SP-MSB15). Filter cartridge to be ordered separately (see
Accessories)
Weight with 2 m cable: approx. 340 g (12.0 oz), + 80 g (2.8 oz) per additional
meter

Note 1:
HC2-IExxx-M probes are the same as HC2-IExxx but are equipped with a stainless steel connector instead of
PPS.

Note 2:
To avoid measurement errors, temperature should be the same on both sides of the mounting wall