Dwyer DPW - Manual (Page 5)

3.LCD KEYPAD OPERATION: DATA ENTRY AND CONFIGURATION
(applicable for LCD options only)
3.1 - Display Indications
Initially, after the power is first turned on, the flow meter model number is shown in
the first line of the display and the revisions for EPROM table and firmware in the
second line. Subsequently the actual process information is displayed. The
instantaneous flow rate is displayed on the first line in percent or in direct reading
units with flow alarm status indication. For flow meters without RTD option, the
main totalizer value, up to 9 digits (including decimal), is displayed in the second
line with its corresponding units.
For flow meters with RTD option, the temperature reading value in deg C, is
displayed in the second line with temperature alarm status indication. This display
is designated as process information (PI) screen throughout the remainder of this
manual.
The temperature value (applicable for RTD option only) in deg F can be displayed
in the PI screen by pressing the ENT pushbutton. The temperature indication can
be switched from deg C to deg F and back by pressing ENT push button.
Figure 3.1: DPW First Banner Screen
Figure 3.2: DPW with RTD Option Initial Process Information Screen
Note: Actual content of the LCD screen may vary depending on the model and
device configuration.
Figure 3.3: DPW without RTD option initial Process Information Screen
Based on flow meter configuration (with or without RTD option), different
parameters may be displayed in the PI screen by pressing the UP or DN
pushbuttons.
3.1.1 - DPW with RTD option Process Information Screens
Pressing UP and DN buttons from initial PI screen will switch display as following:
[Initial PI screen]
Action: Keypad UP
i
Figure 3.4: DPW with RTD Option Process Information
Screen with Main Totalizer
Action: Keypad UP
i
Figure 3.5: DPW with RTD Option Process Information
Screen with Pilot Totalizer
Action: Keypad UP
i
Figure 3.6: DPW with RTD Option PI Screen with Flow Range,
Temperature and Main Totalizer
Action: Keypad UP
i
Action: Keypad UP
i
Figure 3.7: DPW with RTD Option PI Screen with Main Totalizer,
Temperature and Pilot Totalizer
Action: Keypad UP
i
Figure 3.8: DPW with RTD Option PI Screen with Main and Pilot Totalizers
Action: Keypad UP
i
Figure 3.9: DPW with RTD Option Initial Process Information Screen
Pressing UP button, pages through the PI screens in the forward direction.
Pressing DN button, pages through the PI screens in the reverse direction. When
the last PI screen is reached, the firmware "wraps around" and scrolls to the initial
PI screen once again.
Fw: A001 Tbl: A001
5.001 Gl/min AD
20.1 C TA: D
5.001 Gl/min AD
MT: 60639.38 Gal
5.001 Gl/min AD
MT: 60639.38 Gal
5.001 Gl/min AD
PT: 65.81 Gal
Page 5
5.001 Gl/min AD
20.1 C *******Gal
MT: 60639.38 Gal
20.1 C 65.81 Gal
MT: 60639.38 Gal
PT: 65.81 Gal
5.001 Gl/min AD
20.1 C TA: D