Badger Meter M-Series M4000 - Manual (Page 20)

20
6. Press E.
7. A screen, with the statement [(xx mm [xx”] ]
**SELECTED** appears for about 2 seconds.
It verifi es that the selected pipe diameter size parameter
was entered into the amplifi er settings.
8. The screen automatically returns to METER SETUP 10
with the arrow pointed at Exit this Menu.
Transitions
1. Press + or – to position the arrow at another selection or
E to return to the Main Menu.
2. Use the E key to return to screen Main Menu 00.
3. Next, press + three times to position arrow at Inputs/
Outputs.
4. Press E.
5. Press + three times to position arrow at Digital Out. #1 on
screen In/Outputs 30.
6. Press E.
7. Press + once to move the arrow across from Pulses / unit.
8. Press or activate E.
Pulses / Unit 3D is a typical Input Numbers screen.
1. When the screen opens, the arrow is pointing at a
number.
2. Use + or – selections to increase or decrease the
underscored number to the desired digit.
3. Select E to move the underscore to the next digit and
repeat the number selection process.
4. To skip a digit press E. The underscore moves to the next
digit.
5. When all digits are set, press E. Pulses / Unit 3D is
programmed into the system and the screen Dig Output 1