Alicat LC Series Liquid Flow Controller - Manual (Page 37)

37
Data Format:
The data stream on the screen represents the flow parameters of the main
mode in the units shown on the display. For L-Series Flow Meters, there are
three columns of data. The first column is line pressure (normally in psig and
only in units equipped with the optional pressure sensor), the second column
line temperature (normally in °C), and the third column is the volume flow rate
in the units specified at time of order and shown on the display.
+014.70 +025.00 +4.123
+014.70 +025.00 +4.123
+014.70 +025.00 +4.123
+014.70 +025.00 +4.123
+014.70 +025.00 +4.124
+014.70 +025.00 +4.125
L-Series Water Flow Meter Data Format
For LC-Series Flow Controllers, there are four columns of data representing
pressure, temperature, volume flow and set-point. The first column is line
pressure (normally in psig and only in units equipped with the optional pressure
sensor), the second column is temperature (normally in °C), the third column
is volume flow rate (in the units specified at time of order and shown on the
display), and the fourth column is the set-point (also in the units specified at
time of order and shown on the display). For instance, if the meter was ordered
in units of ccm, the display on the meter would read 2.004 ccm and the last two
columns of the output below would represent volume flow and set-point in ccm
respectively.
+014.70 +025.00 +02.004 02.004
+014.70 +025.00 +02.005 02.004
+014.70 +025.00 +02.006 02.004
+014.70 +025.00 +02.005 02.004
+014.70 +025.00 +02.004 02.004
+014.70 +025.00 +02.004 02.004
LC-Series Water Flow Controller Data Format
Note: On units with the totalizer function a fourth column (meters) or fifth
column (controllers) will show the totalizer value