West Control Solutions CALogix User Manual
Page 44
Safety and Warranty Information
Installation
EN61010-1 / UL61010C-1 / CSA 22.2 No 1010
To offer a minimum of basic insulation only
Suitable for measurement within category II and III and pollution degree 2
See Electrical installation
It is the responsibility of the installing engineer to ensure this equipment is installed as specified in this manual and is in
compliance with appropriate wiring regulations.
Configuration
The controller can only be configured using CALogix-sw or CALgrafix software. It is the responsibility of the installing
engineer to ensure that the configuration is safe.
Ultimate Safety Alarms
Do not use SP2/SP3 or logic module outputs as the sole alarm where personal injury or damage may be caused by
equipment failure.
Warranty
CAL Controls warrant this product free from defect in workmanship and materials for three (3) years from data of purchase.
1.
Should the unit malfunction, return it to the factory. If defective it will be repaired or replaced at no charge.
2.
There are no user serviceable parts in this unit. The warranty is void if the unit shows evidence of being
tampered with or subjected to excessive heat, moisture, corrosion or other misuse.
3.
Components which wear or damage with misuse are excluded e.g. relays.
4.
CAL Controls shall not be responsible for any damage or losses however caused, which may be experienced as
a result of the installation or use of this product.
CAL Controls liability for any breach of this agreement shall not exceed the purchase price paid. E & O.E.
Page 44 of 44
CAL Controls Ltd
Bury Mead Road, Hitchin, Herts, SG5 1RT, UK
Tel +44 (0) 1462 436161
Fax +44 (0) 1462 451801
e-mail [email protected]
www.cal-controls.com
CAL Controls Inc
1117 S. Milwaukee Av, Libertyville, IL60048, USA
Tel (847) 680-7080
Fax (847) 816-6852
e-mail [email protected]
www.cal-controls.com
33087/03/0504