West Control Solutions CALogix - Manual (Page 37)

When the input to the block is high (1), the chosen programmer function will be activated.
INVERTING INPUTS
Function block inputs can be inverted in the following way
1. Right-click on function block
2. Click on inputs
3. Click
on invert boxes for the inputs that require inverting.
4.
Click on OK to accept setting.
VALIDATING A PROGRAM
Once a logic program is complete click on icon on the logic toolbar. A check is then carried out for program validity
and any errors are displayed see example below.
WRITING A PROGRAM TO CONTROLLER
Programs are written to the controller by clicking on the logic toolbar. Any changes made to the program before
writing to the controller are only stored on the logic desktop.
As the program is being written to the controller a progress bar is visible.
RUNNING AND STOPPING A LOGIC PROGRAM
Page 37 of 44