KYORITSU 6310 Quick Manual - Manual (Page 37)

− 35 − KEW6310
Flicker
* An optional voltage sensor KEW8325F is required for Flicker measurement.
Steps for measurement
Ensuring your safety
↓
Preparation for measurement
↓
Setting
↓
Wiring
↓
Flicker Range
* Preliminary measurement (for 10 sec) will be done automatically prior to Flicker measurement.
Save data
File ID : 6310-12
Saved time & date
ELAPSED
TIME
Frequency
Voltage Short time
intensity
(for 1 min)
Short time
intensity
Long time
intensity Average Max Min
DATE TIME
ELAPSED
TIME
f AVG_V MAX_V MIN_V
Pst
(1min)
Pst Plt
yyyy/mm/dd h:mm:ss h:mm:ss (±)x.xxxE±nn (±)x.xxxxxE±nn (±)x.xxxE±nn
year/month/ date hour:min:sec hour:min:sec (±) value x 10 ±n
* Data is saved at every 1 min, but Pst is saved at every 10 min and Plt is at every 10 min in 2 hours later.
Saving Flicker data
The saving procedure is same to the one for the other measurements. See the previous corresponding
pages.
Range
Measurement setting Save Setting
Flicker Recording method
V Range Recording start
Filter Recording termination
Output item Destination to save data
Output Threshold Destination to save screen shot
Flicker KEW6310