KROHNE BM 90 EN - Manual (Page 17)

17
3.5.1. Parameter index Level-Sonic BM90
Basic Set-up Open Channel Flow
Pr.1 Application Pr.45 Flow Exponent
Pr.2 Units Pr.46 Max. Flow Rate
Pr.3 Empty Distance Pr.47 Time Base for Flow Rate
Pr.4 Operational Span Pr.48 Totalise Display Conversion
Pr.5 Blanking Distance Pr.49 Control of Ext. Totaliser
Pr.6 Rate of change Pr.50 Penstock Control
Relays Pump Controls
Pr.8 Relay 1 Pr.51 Pump Sequence
Pr.9 Relay 1 Set Pr.52 Duty Standby
Pr.10 Relay 1 Reset Pr.53 Pump Exerciser
Pr.11 Relay 2 Pr.54 Pump Tolerance
Pr.12 Relay 2 Set Pr.55 Pump Maintenance
Pr.13 Relay 2 Reset Pr.56 Run-on-Interval
Pr.14 Relay 3 Pr.57 Run-on-Time
Pr.15 Relay 3 Set
Pr.16 Relay 3 Reset Echo Detection
Pr.17 Relay 4 Pr.68 Echo Selection Algorithm
Pr.18 Relay 4 Set Pr.69 Check Search
Pr.19 Relay 4 Reset Pr.70 Echo Velocity
Pr.20 Relay 5
Pr.21 Relay 5 Set
Pr.22 Relay 5 Reset
Failsafe Miscellaneous
Pr.23 Failsafe R1 Pr.71 Correction Value
Pr.24 Failsafe R2 Pr.72 Parameter Display
Pr.25 Failsafe R3 Pr.73 Software Revision Number
Pr.26 Failsafe R4 Pr.74 Reset Counter
Pr.27 Failsafe R5
Pr.28 Failsafe Analogue
Pr.29 Failsafe Time Delay
Analogue Test Parameters
Pr.30 Analogue Output Pr.75 Digital Output Set
Pr.31 Analogue Value Options Pr.76 HardwareTest
Pr.32 Analogue Datum Pr.77 Transmitter Test
Pr.33 Analogue Span Pr.78 Simulation
Pr.34 Analogue Test
Temperature Number Store
Pr.37 Probe Enable Pr.95 Serial Number Store
Pr.38 Temp. Compensation Pr.96 Security Code Store
Pr.39 Probe Test
Volume Conversion Reset
Pr.40 Vessel Shape Pr.97 Relay Hours/Starts Totaliser Reset
Pr.41 Dimension ’H’ Pr.98 OCM Totaliser Reset
Pr.42 Dimension ’L’ Pr.99 Full System Reset
Pr.43 Display Conversion
Pr.44 Volume Linearisation
NOTE: All other parameters are unused and should not be changed.