ADTRAN ATLAS 810 Plus - Manual (Page 135)

Chapter 11. SNMP Management
61200266L1-1 ATLAS 810 PLUS User Manual 11-5
ber of the trap destination list when accumulated error statistics exceed
these threshold values. Table 11-4 describes the alert traps supported by
ATLAS 810
PLUS
for events that have occurred in the last 15-minute interval.
When one of the Current Alert thresholds is exceeded, the corresponding
event bit is set to 1 in the adDS1CurrentAlert variable in the DS1 alert table.
When enabled, ATLAS 810
PLUS
sends alert traps to each member of the trap
destination list upon detecting status bit changes in adDS1CurrentAlert. If
you have previously set the corresponding enable bit = 1 in the
adDS1CurrentArm variable and adDS1AlertEnable = On, then
ATLAS 810
PLUS
sends an alert trap message. A single alert trap message
may report multiple event changes. ATLAS 810
PLUS
clears the event bits af-
ter sending the trap message or sending the response to a Get request for the
adDS1CurrentAlert variable. ATLAS 810
PLUS
clears the Current Alert values
at the beginning of a new 15-minute interval. Total Alert values are cleared
at the beginning of a new 24-hour interval.
Table 11-5 shows the Total Alert Traps, which describe events that have oc-
curred in the last 24-hour interval.
Table 11-4. DS1 Current Alert SNMP Traps
Current Alert Severity Description
adATLAS800CurrentES Warning The current interval errored second threshold has
been exceeded.
adATLAS800CurrentSES Warning The current interval severely errored second
threshold has been exceeded.
adATLAS800CurrentSEFS Warning The current interval severely errored framing second
threshold has been exceeded.
adATLAS800CurrentUAS Major The current interval is unavailable.
adATLAS800CurrentCSS Warning The current interval path code violations have been
exceeded.
adATLAS800CurrentLES Warning The current interval line errored second threshold has
been exceeded.
adATLAS800CurrentCV Warning The current interval line code violation threshold has
been exceeded.