KROHNE VFM 3100 EN - Manual (Page 17)

17
1. Take electronics end of prepared remote signal
cable and align it as shown at right. Ready for
assembly.
2. As shown in the diagrams at right, push the
prepared cable assembly into the remote
connector. Push until the cable bottoms out
(cannot be pushed in any furher). Push rubber
bushing into position and tighten the knurled
nut onto the remote connector to create a
good compression fit.
Electronics End (Electronic Housing End) Procedures
Push cable
assembly into
connector
Shrink tube or tape
Prepared remote
signal cable
(electronics end)
refer to table 3
Rubber bushing
Knurled nut
Electr
onics
end
Electr
onics
end
2 twisted pairs
Remote
connector
Compression fit of
copper braid in contact
with connector for
shielding
Knurled nut
Remote signal cable
Shrink tube or
electrical tape
Rubber bushing
Table 6. Connection of Remote Signal Cable