KEPCO ABC-DM SERIES - Manual (Page 92)

B-22
ABC 040104
B.93
SYSTem:LANGuage?
QUERY
SYST:LANG?
Syntax: Short Form: SYST:LANG? Long Form: SYSTem:LANGuage?
Return Value: SCPI or COMP
Description: Identifies whether unit responds to older command formats. SCPI means the unit will not
respond to older formats such as LIST:TIME. COMP means the unit will respond to older formats such
as LIST:TIME for compatible operation with software written for ABC power supplies up to Revision 1.
B.94
SYSTem:LANGuage
COMMAND
SYST:LANG
Syntax: Short Form: SYST:LANG {COMP | SCPI} Long Form: SYSTem:LANGuage {COMP | SCPI}
Description:Determines whether unit responds to older command formats. Sending
SYST:LANG COMP causes the unit to respond to older formats such as LIST:TIME for compatible
operation with software written for ABC power supplies up to Revision 1. SYST:LANG COMP has
been selected at the factory to permit the VISA demonstration program (which uses older command
formats) to operate. SYST:LANG SCPI disables responses to older command formats.
B.95
SYSTem:PASSword:CENable
COMMAND
SYST:PASS:CEN
Syntax: Short Form: SYST:PASS:CEN Long Form: SYSTem:PASSword:CENable
Description: Sets the password enable state if the value matches the current password. This command allows
other commands such as *SAV 41 to operate.
B.96
SYSTem:PASSword:CDISable
COMMAND
SYST:PASS:CDIS
Syntax: Short Form: SYST:PASS:CDIS Long Form: SYSTem:PASSword:CDISable
Description: Clears the password enable state if the value matches the current password.
B.97
SYSTem:PASSword:STATe?
QUERY
SYST:PASS:STAT?
Syntax: Short Form: SYST:PASS:STAT? Long Form: SYSTem:PASSword:STATe?
Return Value: 0 or 1
Description: Returns a 1 if the password state is enabled or a 0 if it is disabled.
B.98
SYSTem:SECurity:IMMediate
COMMAND
SYST:SEC:IMM
Syntax: Short Form: SYST:SEC:IMM Long Form: SYSTem:SECurity:IMMediate
Description: Initializes all NVRAM variable to factory defaults. This includes all memory steps to be set to 0 volts,
1.28% of full scale current, overvoltage and overcurrent to be set to Iomax+10%, time value to be set
to 0, and next step equal to 0.).It also initializes the power -up state to have DC Output Control off (see
PAR 3.4.1). The calibration password is reset per Table 4-1 Use master password (see below) If pass-
word has been lost. Related Commands: SYST:PASS:CEN must be sent prior to this command
TABLE B-5. MASTER PASSWORDS
MODEL PASSWORD MODEL PASSWORD MODEL PASSWORD
ABC 10-10 ..10 ABC 25-4 ..20 ABC 60-2 ..40
ABC 15-7 ..60 ABC 36-3 ..30 ABC 125-1 ..50