KANOMAX 3800 Handheld Condensation Particle Counter - Manual (Page 27)

20
- Description of Terms -
3.3.2 Viewing Program
To view measurement program written in from a PC for performing measurement in :
On the MENU (Screen-8) , select “3. PROGRAM REVIEW”, and press the [ENTER] key.
The display will switch to PROGRAM REVIEW screen (Screen-10)
The settings of the program(s) 1-5 can be
viewed by using the [UP]/[DOWN] key.
See the following diagram for
the description of each term.
The program(s) 1-5 are set by using
the supplied software.
For how to write in a program,
See Section 5 “CPC Settings” of the
Software Operation Manual.
Daily measurement at a programmed time can be performed automatically by setting the program
date as 00/00/00.
To return to the MENU
(Screen-8) , press the [ENTER] key or the [LEFT] key.
S-TIMES: 1 2 … m 1 2 … m 1 2 … m
Sampling Suspension
CYCLES : 1 2 ･･･ n
“S-TIME”: Sampling length; t [sec]
“S-TIMES”: Number of sampling times: m [times]
“INTERVAL”: Duration of one measurement cycle; T [sec]
“CYCLES”: Number of cycles; n [cycles]
“START TIME”: Measurement starting time
t
T
Screen-10 PROGRAM REVIEW