In-Situ TROLL Link Telemetry System Operators Manual - Manual (Page 21)

800-446-7488 21 www.in-situ.com
8. Select where to send alarm messages in the Alarm Notification section.
• Select A phone. Enter the destination mobile phone number, and a description if
desired (site name or other information).
-OR-
• Select An email address. Enter a gateway phone number, and enter the
destination email address.
SMS Alarm Messages
The TROLL Link Telemetry System sends alarm messages when an alarm or warning
condition is satisfied. The alarm message contains the time stamp, and then a series of
codes. Refer to the alarm code descriptions in the table below.
Alarm Code Description
AH High alarm
WH High warning
AL Low alarm
WL Low warning
CAL Sensor out of calibration
SC Sensor changed
PWRM Power management disabled
OFLN Device offline
DRST Device hardware reset
DMAL Device malfunction
XPWR No external power detected
TBATT Low TROLL instrument battery
LMEM Low TROLL instrument memory
TLBATT
Low TROLL Link Telemetry System
battery
Configuring Discrete I/O
Skip this section when you do not require a discrete I/O relay.