In-Situ Con TROLL PRO Operators Manual (purchased after 10 May 2012) - Manual (Page 4)

800-446-7488 4 www.in-situ.com
Nominal Stability vs. Full Stability 19
Factory Recalibration 19
4 Aqua TROLL 100 and 200 Instruments 20
Configuring Aqua TROLL 100 and 200 Options 20
Conductivity/Alpha Coefficient 20
Conductivity/Reference Temperature 20
Conductivity/TDS Factor 20
Level/Level Mode (Aqua TROLL 200 only) 20
Level/Specific Gravity (Aqua TROLL 200 only) 21
Calibration Interval 21
Calibrating the Aqua TROLL 100 and 200 Instruments 21
Calibrating Conductivity 21
Zeroing the Pressure Sensor 22
Setting a Level Reference 22
Calibration Hints 22
Nominal Stability vs. Full Stability 22
Factory Recalibration 22
5 Aqua TROLL 400 Instrument 23
Configuring the Aqua TROLL 400 Sensor Options 23
Barometer 23
RDO/Salinity 23
Conductivity/Alpha Coefficient 23
Conductivity/Reference Temperature 23
Conductivity/TDS Factor 24
Level/Level Mode 24
Level/Baro Correction 24
Level/Specific Gravity 24
Calibration Interval 25
Calibrating the Aqua TROLL 400 Instrument 25
Calibrating the Optical RDO Sensor 25
Calibration Options 25
1-Point Calibration 26
Water-Saturated Air 26
2-Point Calibration (100% and 0% Saturation) 27
Calibration using the Concentration Option 28
Calibrating the Conductivity Sensor 28
Calibrating Pressure/Level 29
Zero Pressure 29
Calibrating the pH/ORP Sensor 29
Calibrating the pH Sensor 29
Calibrating the ORP Sensor 30
Calibration Hints 30
Nominal Stability vs. Full Stability 30
Factory Recalibration 30
Cal. Report 31