In-Situ Con TROLL PRO Operators Manual (purchased after 10 May 2012) - Manual (Page 3)

800-446-7488 3 www.in-situ.com
Table of Contents
1 Getting Started 6
Probe Installation Requirements 6
Navigating Through the Menus 6
Menu Diagram 7
Initial Configuration 7
Using the View Function 8
Changing the Date and Time 9
Display (Screen) Appearance 9
Locking the Display 9
Changing the Display Contrast 9
Changing the Displayed Location 9
Changing the Back-light Time 9
Changing the Auto-Off Time (DC-L Model Only) 10
Changing the Language 10
On-Screen Icon Descriptions 11
Setting the Log Interval 11
Setting the Communications Preferences 12
Setting the Device Address for the Controller (RS485 Instruments Only) 12
Setting the RS485 Settings for the Controller 12
Enabling Bluetooth Communications on the Controller 12
Pairing Bluetooth Devices 12
Administrator and Password Access 13
2 Configuring Probes 14
Adding a Probe After Initial Configuration or Deletion 14
Deleting a Probe 14
Replacing a Probe 14
Enabling and Disabling Parameters 14
Setting Parameter Units 15
Settings Parameter Resolution (Setting Significant Units) 15
Setting the Sentinel Value (Offline/Error Value) 15
3 RDO PRO or RDO PRO-X Probe 16
Configuring RDO PRO or RDO PRO-X Options 16
Barometer 16
Salinity 16
Calibration Interval 16
Calibrating the RDO PRO or RDO PRO-X Probe 16
Calibration Options 16
1-Point Calibration 17
Water-Saturated Air 17
Controller 1-Point Calibration 17
Controller 2-Point Calibration (100% and 0% Saturation) 18
Calibration using the Concentration Option 19
Calibration Hints 19