Setting parameter units, Setting the sentinel value (offline/error value) – In-Situ Con TROLL PRO Operators Manual (purchased after 10 May 2012) User Manual
Page 15

800-446-7488
15
www.in-situ.com
Setting Parameter Units
1. From the main screen, select Menu, Settings, Probes.
2. Select a probe.
3. Select parameters.
4. Use the arrow keys to scroll to the selected parameter. Select Enter.
5. Select Units.
6. Use the arrow keys to scroll to the correct unit of measure. Select Enter.
Settings Parameter Resolution (Setting Significant Units)
1. From the main screen, select Menu, Settings, Probes.
2. Select a probe. (Remember that Probe C is the controller.)
3. Select Parameters.
4. Use the arrow keys to scroll to the selected parameter. Select Enter.
5. Select Resolution.
6. Continue to press Select in order to move the decimal point. When you achieve the
desired resolution, press Back.
Setting the Sentinel Value (Offline/Error Value)
To set a value to display when the probe returns an error condition for a parameter.
1. Select Menu, Settings, Probes.
2. Select a probe. (Remember that Probe C is the controller.)
3. Select Parameters.
4. Use the arrow keys to scroll to the selected parameter. Select Enter.
5. Select Sentinel.
6. Use the arrow keys to set the sentinel (error) value. Select Enter.