In-Situ Con TROLL PRO Operators Manual (purchased after 10 May 2012) - Manual (Page 14)

800-446-7488 14 www.in-situ.com
Configuring Probes
Adding a Probe After Initial Configuration or Deletion
1. From the main screen, select Menu, Settings, Probes.
2. Select Probe A or B, then Add Probe.
3. The Add Probe screen appears with the name of the sensor that is wired in this
position. If there is no probe detected, the display will tell you that no probe is
connected. Select Enter to add and configure the probe.
Deleting a Probe
If you plan to permanently remove a probe or remove the probe and replace it with a
different type of probe, follow the steps below.
1. From the main screen, select Menu, Settings, Probes.
2. Highlight the probe that you want to remove and press Select.
3. Use the arrow keys to scroll down to Delete Probe.
4. Press Select, then Enter to confirm.
5. The probe has been deleted from the configuration. Refer to the Con TROLL PRO
Installation Manual to physically remove the probe from the controller and add a
different probe.
Replacing a Probe
If you want to replace a probe with the same model and type of probe (i.e., Level
TROLL 300 with a Level TROLL 300 or Aqua TROLL 100 with an Aqua TROLL 100),
you can replace a probe directly and retain the existing settings.
1. Refer to the Con TROLL PRO Installation Manual, Input/Output Connection for
directions on safely disconnecting the existing probe and replacing it with the same
model of probe.
2. From the main screen, select Menu, Settings, Probes, the probe type, Replace
Probe, Enter. The controller will configure the probe.
3. Press and hold the Back option to return to the display screen.
Enabling and Disabling Parameters
In most situations, you will only need to monitor or log specific parameters rather than
every possible parameter. For example, each probe and the controller are capable of
measuring/logging temperature, but you may only want to measure temperature from
one probe. Thus, you will want to disable some parameters while leaving others
enabled.
1. Select Menu, Settings, Probes.
2. Select a probe, then select parameters.
3. Select a parameter from the list and select Disable to stop logging or viewing that
parameter.
Any change to the configuration of the parameters (add probe,
delete probe, enable/disable parameters, change units, etc.) will
cause the data log to be erased and restarted.