GW Instek GDS-1000A Series Freewave user manual - Manual (Page 44)

Freewave Manual
44
Configuring and Running the Commands
1. Prepare the command list according to the previous section.
2. Configure the parameters of the commands.
 To change from “Set” to “Query”, simply double-click on the
“Set/Query” row.
→
 To change from “Query” to “Set”, double-click on the
“Set/Query” row and then enter the setting value in the dialog
box. The parameter mode changes to “Set” with a new value.
→ →
 To change the setting value, first change the mode from “Set” to
“Query” by double-clicking on the row, then reset the value.
→ →
→
3. Click on the Play button. The commands run
automatically in sequence and the returned values
will be displayed in the “Value” row.