GW Instek PST series Programming Manual - Manual (Page 17)

PST & PSS & PSH SERIES PROGRAMMABLE POWER SUPPLY
PROGRAMMER MANUAL
⎯ 31 ⎯
Returns
Examples
STATus:OPERation:ENABle 32767 sets all 15 bits of the register
to 1.
If the STATus:OPERation:ENABle? returns 0, all 15 bits of the
register are 0.
STATus:OPERation:EVENt (query only)
Function:
Returns and clears the contents of the OPERation register.
Syntax:
STATus:OPERation:EVENt?
Returns:
Examples:
STATus:OPERation:EVENt? returns 0.
STATus:PRESet
Function:
Set the OPERation and QUESTionable enable registers to zeros.
Syntax:
STATus:PRESet
STATus:QUEStionable:CONDition? (query only)
Function:
Return the contents of the QUEStionable register. Reading the condition
PST & PSS & PSH SERIES PROGRAMMABLE POWER SUPPLY
PROGRAMMER MANUAL
⎯ 32 ⎯
register is non-destructive.
Syntax:
STATus:QUEStionable:CONDition?
Returns:
Examples:
STATus:QUEStionable:CONDition? returns 0.
STATus:QUEStionable:ENABle
Function:
Set or query the enable mask that allows the masked conditions in the
event register to be reported in the summary bit. If a bit is 1 (true) in the
enable register and its associated event bit changes to 1 (true), the
associated summary bit will change to 1 (true). Even though this is a 16-
bit register, only 15 bits (bit 0 through bit 14) are used. Bit 15 always
reads 0.
Syntax:
STATus:QUEStionable:ENABle
STATus:QUEStionable:ENABle?
is an integer from 0 to 32767.
Returns:
Examples:
STATus:QUEStionable:ENABle 32767 sets all 15 bits of the
register to 1.
If the STATus:QUEStionable:ENABle? returns 0, all 15 bits of the
register are 0.