beautypg.com

GW Instek SFG-2000 Series User Manual

Page 9

background image

GETTING

STARTED

17

Amplitude/
Attenuation
control

ADJ

−20dB

AMPL

Sets the sine/square/triangle waveform

amplitude. Turn left (decrease) or right
(increase).

When pulled out, attenuates the

sine/square/triangle waveform

amplitude by −20dB. The −20dB display
turns On.

For details, see page29.

DC offset
control

CAL

ADJ

OFFSET

-

+

When pulled out, sets the DC

offset level for sine/square/triangle

waveform. Turn left (decrease) or right
(increase). The range is −5V ~ +5V, in
50Ω load.

For details, see page30.

CMOS
amplitude
control

TTL

CMOS ADJ

TTL/CMOS

5V

15V

This knob becomes effective when the

TTL/CMOS output is enabled (page31).

Selects TTL as output.

When pulled out, selects CMOS

as output. Sets the CMOS output level.
Turn left (decrease) or right (increase).

Sweep speed
control

Log/Linear
sweep selector

LIN

LOG

SWEEP TIME

SLOW

FAST

This knob is available in SFG-2100
series only. It becomes effective in

sweep time mode.

Sets the sweep speed. Turn left (slow) or
right (fast). The range is 1 ~ 30 seconds.

For sweep details, see page35.

Selects linear sweep.

When pulled out, selects

logarithmic sweep.

SFG-2000 Series User Manual

18

Sweep span
control

AM/FM
modulation
control

FM Dev

AM %

SWEEP SPAN

0

MAX

This knob is available in SFG-2100
series only. It becomes effective in

sweep mode and AM/FM mode.

In Sweep mode: Sets the sweep span.
Turn left (narrow) or right (wide). The

range is 1 ~ 100. For sweep details, see
page36.

In AM/FM mode:

Sets the FM deviation (page38).

Turn left (decrease) or right (increase).

The range is over −50kHz ~ +50kHz,
centered at 1MHz.

When pulled out, sets the AM

depth (page37). Turn left (shallow) or

right (deep). The range is 0 ~ 100%.

Power switch

Turns the main power On/Off. For

power up sequence, see page20.

This manual is related to the following products: