Ine/square/triangle wave, Select the waveform, Set the frequency – GW Instek SFG-2000 Series User Manual
Page 13
SINE/SQUARE/TRIANGLE
WAVE
25
S
INE/SQUARE/TRIANGLE
WAVE
Select waveform Select the waveform............................................... 26
Set frequency
Enter frequency ...................................................... 26
Edit frequnency ...................................................... 27
Set duty cycle
(for square
wave)
Enter duty cycle...................................................... 28
Edit duty cycle........................................................ 28
Set amplitude
Normal output ....................................................... 29
Attenuate by −20dB ............................................... 29
Set offset
Activate offset ........................................................ 30
Adjust offset .......................................................... 30
Limitation .............................................................. 30
SFG-2000 Series User Manual
26
Select the waveform
Sine / Square
/ Triangle
Press
WAVE
key repeatedly. The corresponding icon
appears on the display.
Sine waveform.
Square waveform.
Triangle waveform.
OUTPUT
50
Ω
The waveform comes out from the main
terminal.
10Vp-p maximum (50Ω load)
20Vp-p maximum (no load)
Set the Frequency
Enter the waveform frequency using the numerical keys.
1
2
MHz
1.2MHz
Enter
frequency
kHz
3
7
37kHz
5
4
Hz/%
45Hz
MHz
Delete a number
(backspace)
Triangle waveform frequency is limited to
maximum 1MHz. When the input exceeds it, the
following message (Freq-Err2) appears and forces the
frequency to 1MHz.
For full error message list, see page52.