beautypg.com

Mplitude modulation, Requency modulation – GW Instek SFG-2000 Series User Manual

Page 19

background image

AMPLITUDE

MODULATION

37

A

MPLITUDE MODULATION

AM applies only to SFG-2100 series.

Modulation and Sweep (page35) cannot be used together.

Activate AM

1. Output the waveform, Sine/Triangle/Square

(page25).

2. Press the Shift key, then Dot (AM). AM is activated

and the sign appears on the display.

AM

AM %

SWEEP SPAN

0

MAX

1. Pull the SWEEP SPAN knob (AM

%).

2. Turn the knob left (shallow) or

right (deep).

Set AM depth

Range

0 ~ 100%

SFG-2000 series uses an internal 400Hz sine wave as the

default modulating signal.
1. Connect the modulating signal to the rear panel

terminal.

2. Press the Shift key, then 0 (EXT MOD). External

modulation is activated.

0

EXT

Use external
modulating
signal

Frequency Range

DC ~ 1MHz

SFG-2000 Series User Manual

38

F

REQUENCY MODULATION

FM applies only to SFG-2100 series.

Modulation and Sweep (page35) cannot be used together.

Activate FM

1. Output the waveform. Sine/Triangle/Square

(page25) or TTL/CMOS (page31).

2. Press the Shift key, then 4 (FM). FM is activated and

the sign appears on the display.

FM

4

When FM is activated, the duty cycle of
Square/TTL/CMOS wave is fixed to 50%.

The output frequency becomes the Center Frequency.

FM Dev

AM %

SWEEP SPAN

0

MAX

1. Push the SWEEP SPAN knob

(FM Dev).

2. Turn the knob left (shallow) or

right (deep).

Set FM
deviation

Deviation
Range

0 ~ ±50kHz, centered at 1MHz

This manual is related to the following products: