GW Instek SFG-2000 Series - Manual (Page 23)

APPLICATION EXAMPLES
45
Transistor DC Bias Characteristics Test
Description Use SFG-2000 series as the signal source for a transistor.
Compare the transistor input/output waveform using the
oscilloscope. Adjust the DC voltage source to find out
the maximum output without distorting the waveform.
Block diagram
SFG series Oscilloscope
Transistor
V+
V-
Input
Output
Oscilloscope
display
SFG-2000 Series User Manual
46
Amplifier Over-Load Characteristic Test
Description Use the triangle wave output from SFG-2000 series to
check the amplifier output distortion caused by overload.
The common sine wave is not the ideal source in this
case. Observe the linearity of the triangle waveform
using an oscilloscope.
Block diagram
SFG series Oscilloscope
Amplifier
Triangle wave
Load
Amplifier Transient Characteristics Test
Description Use the square wave output from SFG-2000 series to
check the transient frequency response of an amplifier.
The common sine wave is not the ideal source in this
case. Observe the waveform using an oscilloscope.
Block diagram
SFG series Oscilloscope
Amplifier
Square wave
Load