GW Instek GOS-652G - Manual (Page 9)

⎯ 4 ⎯
20MHz OSCILLOSCOPE 35MHz 50MHz OSCILLOSCOPE MODEL
SPECIFICATIONS 622G 626G 623G 635G 652G 653G 658G
Horizontal axis display A, A INT, B, B TRIG’D (623G, 653G&658G)
A sweep(main sweep ) time 0.1μs ～ 0.5s/DIV, 21 steps in 1-2-5 sequence
Sweep time accuracy ±3%, (10℃ to 35℃ ( 50℉ to 95 °F ) )
Vernier sweep time control ≤ 1/2.5 of panel-indicated value
Hold off time Continuous variable ≧ twice sweep length (time) at 0.1
µSec~1mSec/DIV ranges.
B sweep delay system
B sweep(delay sweep) time
Sweep time accuracy
Delay time
Delay jitter
Continuous delay and triggered delay
0.1μs～0.5ms/DIV, 12 steps
±3%, (10℃ to 35℃( 50℉ to 95℉ ) ) (623G, 653G&658G)
1μs ～ 5ms
≤ 1/10000
Sweep magnification 10 times ( maximum sweep time 10ns/DIV )
×10MAG sweep time accuracy 0.1μs～50ms/DIV ±5%, 10ns～50ns/DIV ±8% (10℃ to 35℃(50℉ to 95℉))
Linearity NORM:±3%, ×10MAG:±5% (±8% for 10ns～50ns/DIV)
HORIZONTAL
AXIS
Position shift caused by x10MAG Within 2 div. at CRT screen center
Sensitivity Same as vertical axis.(X-axis:CH1 input signal; Y-axis:CH2 input signal.)
Sensitivity accuracy NORM:±4%, ×10MAG: ±6% (10℃ to 35℃(50℉ to 95℉))
Frequency bandwidth DC ～ 1MHz (-3dB) DC ～ 2MHz (-3dB) X-Y MODE
X-Y phase difference
≤3º at DC ～50kHz ≤3º at DC ～100kHz
Sensitivity
Approx. 0.1V/DIV (Trace swept by an external horizontal signal applied to the EXT TRIG IN terminal.
Vertical axis modes are CH1,CH2,DUAL and ADD modes in the CHOP mode.)
Frequency bandwidth DC ～ 1MHz (-3dB) DC ～ 2MHz (-3dB)
EXT HOR
MODE
Phase difference between vertical
axis ≤ 3º at DC ～50kHz ≤ 3º at DC ～100kHz
Sensitivity 3 Vp-p ( Trace becomes brighter with negative input.)
Frequency bandwidth DC ～5MHz
Input resistance Approx. 5k ohm Z AXIS
Maximum input voltage 50 V ( DC+AC peak, AC frequency
≤ 1kHz )